Week 11: Taranis Setup



We just got the brand new taranis and have to go through the process of setting it up. Setting it up requires creating the aircraft file in the controller and putting the proper output setting. We then have to bind it to the receiver and go into the NAZA program on the computer and set an arm switch and make sure all of the outputs are registering in it and not reversed.

Comments

Post a Comment

Popular posts from this blog

Week 13: ALMOST THERE

Today we dialed in the quad with gps with a quick trip to home depot to get some super glue to tighten her down. after we got the quad flying with it and tested it with some wind. Even with a slight wind the quad kept its place in the air and performed beautifully. WITHOUT CRASHING... For once.
Read more

Week 14 - Finished

Image
We are done with our project. Our goal was to get as many drones flying as we could. We ended up getting 2 AR2.0s flying and the quad. I think we could have got more don't if we didn't spend so much time on the hexacopter but at least we got it all put together. We also got the taranis transmitter set up so we could use it on most of the drones we build here. These are pictures of the completed taranis and quad.
Read more